General Information
Note
BoX2 pro motion is only partly covered in this manual. For more information on configuring the BoX2 pro motion, see the BoX2 pro motion and BSD Start up manual (KI00390).
Important
When updating the system image through “Make recovery SD card” an SD card formatted with FAT16/FAT32 and maximum 32 GB must be used.
Default IP Addresses
These are the default IP addresses for the BoX2 devices:
BoX2 base v2, extreme (incl. SC), pro (incl. SC) | BoX2 pro motion | |
|---|---|---|
LAN A | 192.168.1.1 | None (EtherCAT) |
LAN B | DHCP | 192.168.1.1 |
Note
Devices with 2 Ethernet ports MUST NOT have IP addresses in the same subnet.
Open Ports
In the firmware there are some ports that are open by default due to the operating system or that the internal application requires it.
LED Indication
BoX2 uses three colors for LED indication; Red, Purple and Blue.
Red
State | Description |
|---|---|
Constant on | Unit is busy booting, or updating image through recovery SD card. |
Every 2 seconds on/off | Unit is in standby/update mode. If image recovery has been run, then this indicates it has finished, eject SD card and reboot unit. |
Fast flashing | Eject USB/SD card. NoteFast flashing continues for a couple of seconds after ejecting the USB/SD card. |
Purple
State | Description |
|---|---|
Constant on | Operating system is booting up. |
Every 0.5 seconds on/off | The unit is on standby and no iX Runtime or CODESYS project is running. |
Fast flashing for 5 seconds | USB/SD card project (iX or CODESYS) update successful. |
Blue
State | Description |
|---|---|
Every 0.5 seconds on/off | The iX project is running. |
Every 0.5 seconds, short flash | CODESYS project is running. |
Every 0.5 seconds, alternately short and long flash | Both iX and CODESYS running. |
Note
If the LED alternatively flashes Red to Blue to Purple, the wrong image type is installed. Please reinstall correct image.